Mechanical Use Of Straight Side Press

            Improper pressure machine operation or stamping die setting can cause the failure and shutdown of the main cause of the press. Proper training of the press operator and the stamping die setting will ensure that they operate in the correct process. This will quickly reduce downtime.

            Each shift before the operation to the operator of the brake shaft to add lubricating oil, pole ball first class daily before the shift with oil gun to add No. 20-30 mechanical oil, clutch parts every day before class with oil gun pressure injection lubricating oil once. The machine is cleaned before each class stops.

Check fasteners for external missing parts. Check clutch and spring, belt. Check the lubrication device of the machine tool. Check electrical wiring Damage, aging, motor, electromagnet is normal. Check the accuracy and wear of crankshaft guide rails. Check brake, clutch, slider, close block, close ring. Check the electrical control section. Check and adjust the connecting bolts of the fuselage table.Straight Side Press

            According to the different machine types and processing requirements of the press, the establishment of targeted, practical safety procedures, and the necessary job training and safety education. The use of units and operators must strictly comply with the safety instructions provided by the design and manufacturing units and operating procedures, the correct use and maintenance. The general safety operation requirements of the press are as follows: Before moving equipment, check whether the control part of the press, clutch and brake are in effective condition, whether the safety protection device is intact, and the crank-slider mechanism has no abnormality. The abnormality should be taken immediately and the necessary measures shall not be carried out, and the safety device should not be disassembled and damaged. Before the formal operation must be run by idling test, to confirm that all parts of the normal rear can work. Should clean up all unnecessary items on the workbench before turning on, to prevent the driving vibration or impact switch causing the slider to suddenly start. The operation must use the tool, is strictly prohibited to use the hand directly into the mold mouth extract, hand tools must not be placed on the mold.Straight Side Press

           The foot must be removed from the foot pedal when the workpiece position is adjusted in the die area or the workpiece in the mold is uncovered. Many people operate the same pressure machine should be unified command, signal clear, to the other side to make a clear answer, and confirm the risk of leaving the danger again. A sudden power outage or operation should be turned off power, and the manipulator to return to the clutch air, the brakes in the braking state. The press to overhaul, adjust and install, adjust, disassemble the mold, the machine tool should be disconnected from energy (such as electricity, gas, liquid), machine tools to stop operation, and under the slider to add the cushion block reliable support. The machine tool starts the switch place to announce the warning.Straight Side Press